I have a problem with the trans in a 2000 S10 4.
2-inch column with 5 position tilt provides easy entry/exit and custom driving position. if i click it into the 2nd gear position, it'll stay in 3rd, but if i click just a tad into the 1st position and back into 2nd, it'll go. im baffeled now and could use helpyou can take off in all gears. 3 lt Question: transmission will not shift into drive and overdrive checked fluid OK i think a shift solenoid tranny is a 4L60-E tell me what else to check there is a check engine lite on do not code for transmission valve or shift solenoid answer my question please. be sure the pressure plate, throughout bearing, and slave cylinder are in position. The cable speedo tail housing from a 1986 and earlier S10 (or GMC S15) is hard to find but you will need it if you want to use a cable driven speedometer. A more logical solution would be a rebuilt Chevy S-10 transmission. Before it quit shifting it would start off in like 3rd gear if The shifting solenoid on a Chevrolet S-10 pick-up is designed to regulate when the transmission shifts. It was a heavy vehicle at 4,199 pounds, but its payload remained approximately 951 pounds. ∙ 06:00:31 transmission wont shift into 3rd and OD and speedometer quit working same time. At ~2500 RPM with only enough throttle to maintain speed (transmission manually shifted to 3rd gear), it will surge and hunt. 50 WARNING: DO NOT ALLOW SHIFT KNOB TO "BOTTOM OUT" ON SHIFTER SHAFT. These include checking to see if the parking brake is stuck, finding the shift lock solenoid override (if applicable), and the shift linkage. 95: 1995 Chevy S10 Pickup 2WD 1996 Chevy S10 Pickup 2WD 1997 Chevy S10 Pickup 2WD 1998 Chevy S10 Pickup 2WD The numbers cast in the housing do not give you the year and OD ratio.
0 kommentar(er)
